Cleaning And Maintenance - cecotec FORCE CLIMA 12500 COLD&WARM Manuel D'instructions

ENGLISH

6. CLEANING AND MAINTENANCE

Disconnect the appliance from the power supply and allow it to cool down before cleaning.
Use a soft, damp cloth to clean the product's surface. Do not use chemical such as benzene,
alcohol or gasoline, as it might damage the device. figure 14
Do not immerse the appliance in water or other liquid.
Do not use abrasive scouring pads, powders or cleaners.
Clean the filter once every two weeks.
To clean the filter net and the CON filter, unscrew the screw fixed on the back and take the net
out. Wash it with warm water and neutral detergent (about 40ºC / 104ºF) and dry it. Clean the
net with a damp cloth.
To clean the filter net and the EVA filter, press both upper flaps and remove it. Wash it with
warm water and neutral detergent (about 40ºC / 104ºF) and dry it. Clean the net with a damp
cloth.
7. TROUBLESHOOTING
Do not repair or disassemble the air conditioning by yourself. Unqualified repair will lead to
failure of the warranty card and may cause damage to users or their properties.
Problems Reasons
There is no electricity.
The overflow indicator displays
"FL".
The room temperature is too low
or too high
The air
conditioning
In cooling mode, the room
does not work
temperature is lower than the set
temperature; in heating mode, the
room temperature is higher than
the set temperature.
In dehumidification mode, the
room temperature is low.
24
FORCE CLIMA 12500 COLD&WARM / FORCE CLIMA 14500 COLD&WARM
Solutions
Turn the device on after connecting
it to a socket with electricity.
Discharge the water inside.
We recommend that you use the
device in a temperature of 7-35 ℃
(44-95 ℉).
Change the set temperature.
The device is placed in a room with
an room temperature higher than 17
℃ (62 ℉).