AEG AGN71200F1 Notice D'utilisation page 27

Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The FROSTMATIC function
is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Food products are not wrap-
ped properly.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The FROSTMATIC or COOL-
MATIC function is switched
on.
The appliance is in demon-
stration mode.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The FROSTMATIC function
is switched on.
ENGLISH
Solution
Refer to "FROSTMATIC
function".
Refer to "Closing the door".
Wrap the food products bet-
ter.
The compressor starts after a
period of time.
Attach the melting water
outlet to the evaporative
tray.
Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FROST-
MATIC or COOLMATIC
function".
Keep the OK button pressed
for approximately 10 sec-
onds until a long sound is
heard and display shuts off
for a short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Refer to "FROSTMATIC
function".
27