3. Adjust Parameter Settings
1. Locate the PC Board (lower left side of unit) (Figure 3).
2. Locate the red button on the PC Board (Figure 3).
3. Press and hold the red button for five seconds (Figure 3).
Figure 3
4. Press the Mode button on the controller. Press
the
(Up) or
5.
Press the Select button.
6.
Press the
(Up) or
the appropriate gas type.
A
•
Select
for Natural Gas (NG)
•
Select
for Propane (LP)
Then, press the Select button.
7. Parameter settings are complete. To enter normal operation mode, press the Mode button.
Rinnai I-Series Boiler Conversion Manual
PC Board
(Down) arrows to select
(Down) arrows to select
a0-A
A0
.
a0-A
NATURAL GAS
A0-A
Press Red Button for
Five Seconds
PROPANE
Ao-
5
Red
Button
7