Electric Dryer; Before You Begin; Tools You Will Need; For Your Safety - GE UPSE810 Manuel D'utilisation

Electric Dryer

BEFORE YOU BEGIN

Read these instructions completely and carefully.
IMPORTANT
•
and ordinances.
• Note to Installer - Be sure to leave these instructions
with the customer.
• Note to Customer - Keep these instructions with your
Use and Care Book for future reference.
• Exhausting the dryer to the outdoors is strongly
recommended to prevent large amounts of moisture from
being blown into the room.
• Before the old dryer is removed from service or
discarded, remove the dryer door.
• Service information and the wiring diagram are located in
the control console.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance
is used near children.
TOOLS YOU
WILL NEED
SLIP JOINT PLIERS
FLAT BLADE SCREWDRIVER
PHILLIPS SCREWDRIVER
LEVEL
Step 1 Prepare the Area and Exhaust for Installation of
New Dryer (see section 1).
Step 2 Check and Ensure the Existing External Exhaust is
Clean (see section 1) and Meets Attached
Installation Specifications (see section 3).
Step 3 Remove the Foam Shipping Pads (see section 1).
Step 4 Move the Dryer to the Desired Location.
Step 5 Connect the Power Supply (see section 2).
Step 6 Connect the External Exhaust (see section 4).
Step 7 Level Your Dryer (see section 5).
5
Questions on Installation? Call: 1-800-561-3344
or Visit our Web site at: www.GEAppliances.ca
- Observe all governing codes
MATERIALS YOU WILL NEED
4" DIA. METAL DUCT
(RECOMMENDED)
4" DIA. FLEXIBLE METAL DUCT
(IF NEEDED)

FOR YOUR SAFETY:

WARNING
• Use only rigid metal or flexible metal 4-in. diameter
ductwork for exhausting to the outdoors. Never use
plastic or other combustible, easy-to-puncture ductwork.
• This appliance must be properly grounded and installed
as described in these instructions.
• Do not install or store appliance in an area where it will
be exposed to water and/or weather.
• Install the dryer where the temperature is above 50ºF for
satisfactory operation of the dryer control system.
NOTE: Installation and service of this dryer requires
basic mechanical and electrical skills. It is your
responsibility to contact a qualified installer to make the
electrical connections.
4" DIA. METAL
4" DUCT
ELBOW
CLAMPS (2)
OR
4" SPRING
CLAMPS (2)
DUCT TAPE
Step 8 Check the Operation of the Power Supply and
Venting.
Step 9 Place the owners manual and the installation
instructions in a location where they will be noticed
by the owner.
For Alcove or Closet Installation, see section 6.
For Bathroom or Bedroom Installation, see section 7.
For Mobile or Manufactured Home see, section 8.
For side or bottom exhaust, see section 9.
www.GEAppliances.ca
EXHAUST HOOD SAFETY GLASSES
GLOVES