GE UPSE810 Manuel D'utilisation page 19

ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
• Insert the elbow through the rear opening and connect it
to the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 18.
CAUTION: Internal duct joints must be secured with
tape, otherwise they may separate and
cause a safety hazard.
ADDING COVER PLATE TO REAR OF CABINET
PLATE
(KIT WE1M454)
Connect standard metal elbows and ducts to complete the
exhaust system. Cover back opening with a plate
(Kit WE1M454) available from your local service provider.
Place dryer in final location.
WARNING - NEVER LEAVE THE BACK
OPENING WITHOUT THE PLATE.
For Questions on Installation, Call: 1-800-561-3344
500A280P019
24
ROTATE DOOR 180
AND REINSTALL.
(Kit WE1M454)
25
DISCONNECTION WHEN SERVICING
CONTROLS. WIRING ERRORS CAN CAUSE
IMPROPER AND DANGEROUS OPERATION
AFTER SERVICING/INSTALLATION.
For replacement parts and other information, refer to Owner's
Manual for servicing phone numbers.
Pub # 31-16077
19
CHANGING DIRECTION OF DOOR
OPENING
REMOVE 4 HOLE PLUGS AND
PLACE THEM IN THE HOLES
REMOVE 4
ON THE OPPOSITE SIDE.
HINGE SCREWS.
0
SERVICING
WARNING - LABEL ALL WIRES PRIOR TO