Gas Dryer - GE UPSE810 Manuel D'utilisation

Gas Dryer

BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
•
local inspector's use.
IMPORTANT
•
and ordinances.
• Note to Installer - Be sure to leave these instructions
with the customer.
• Note to Customer - Keep these instructions with your
Use and Care Book for future reference.
• This dryer must be exhausted to the outdoors.
• Before the old dryer is removed from service or
discarded, remove the dryer door.
• Service information and the wiring diagram are located in
the control console.
• Service of this dryer must be performed by a qualified
installer, service agency, or the gas supplier.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance
is used near children.
TOOLS YOU
WILL NEED
SLIP JOINT PLIERS
10" ADJUSTABLE WRENCHES (2)
FLAT BLADE SCREWDRIVER
8" PIPE WRENCH
Step 1 Verify Your Gas Installation (see section 13).
Step 2 Prepare the Area and Exhaust for Installation of
New Dryer (see section 12).
Step 3 Check and Insure the Existing External Exhaust is
Clean (see section 12) and Meets Attached
Installation Specifications.(see section 17)
Step 4 Remove the Foam Shipping Pads (see section 12).
Step 5 Move the Dryer to the Desired Location.
Step 6 Level Your Dryer (see section 19).
Step 7 Connect the Gas Supply (see section 14) and
check for leaks (see section 15).
Questions on Installation? Call: 1-800-561-3344
or Visit our Web site at: www.GEAppliances.ca
- Save these instructions for
- Observe all governing codes
4" DIA. METAL
PIPE COMPOUND
FLEXIBLE GAS LINE CONNECTOR
LEVEL
FOR YOUR SAFETY:
WARNING
• Use only rigid metal or flexible metal 4-in. diameter
ductwork for exhausting to the outdoors. Never use
plastic or other combustible easy-to-puncture ductwork.
• This appliance must be properly grounded and installed
as described in these instructions.
• Do not install or store appliance in an area where it will
be exposed to water and/or weather.
• The National Fuel Gas Code restricts installations of gas
appliances in garages. They must be 18 in. off the ground
and protected by a barrier from vehicles.
• Install the dryer where the temperature is above 50ºF for
satisfactory operation of the dryer control system.
In the state of Massachusetts
Installation must be performed by qualified or licensed
contractor, plumber, or gasfitter qualified or licensed by
the state.
MATERIALS YOU WILL NEED
4" DIA. METAL DUCT
ELBOW (RECOMMENDED)
4" DIA. FLEXIBLE METAL DUCT
(IF NEEDED)
GLOVES
Step 8 Connect the External Exhaust (see section 18).
Step 9 Connect the Power Supply (see section 16).
Step 10 Check the Operation of the Power Supply, Gas
Connections, and Venting.
Step 11 Place the Owners Manual and the Installation
Instructions in a Location Where They Will Be
Noticed By the Owner.
For Alcove or Closet Installation see section 20.
For Bathroom or Bedroom Installation see section 21.
For Mobile or Manufactured Home see section 22.
www.GEAppliances.ca
SOAP SOLUTION
DUCT
FOR
CLAMPS (2)
LEAK DETECTION
EXHAUST HOOD
SAFETY GLASSES DUCT TAPE
12