Control Panel - RCM BIT 391CB Utilisation Et Entretien

EN

6.1 CONTROL PANEL

(Fig. 8)
1) LEDs status of battery charge
(only for BC version)
This lights up when the button (3) is set
to "I" or "II", indicating the level of battery
charging.
- When the LED lights up green, this
indicates that the battery is fully
charged.
- When the LED lights up orange, this
indicates that the battery is approxi-
mately half-charged.
- When the LED lights up red, this indi-
cates that the battery is at its minimum
level.
With the battery discharged [red LED il-
luminated], the machine turns off or will
not start and the LED "R" of the battery
charger flashes for a few seconds; the
battery needs recharging.
2) Aspirator button
By setting the button (2) to "I", the aspira-
tor begins to operate.
Aspirator operation is enabled when the
button (3) is set to "I" or "II".
3) Brush rotation/water supply button
By setting the button (3) to "I", the circuits
are powered and brush rotation is ena-
bled.
The starting of rotation of the brush is
controlled by pressing levers (4).
By setting the button (3) to "II", the circuits
are powered and brush rotation and wa-
ter supply are enabled.
The start of brush rotation and water sup-
ply is controlled by the levers (4).
4) Brush rotation and/or water dispens-
ing lever
Pressing the levers (4) and holding them
pressed, starts the rotation of the brush
and, if enabled, the dispensing of water.
2
4
EN-12
1
4
3
R
Fig. 8