Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
About This Guide
The Intimidator Beam 140SR Quick Reference Guide (QRG) has basic product information such as mounting, menu
options, and DMX values. Download the User Manual from
Disclaimer
The information and specifications contained in this QRG are subject to change without notice.
Safety Notes
These Safety Notes include important information about installation, use, and maintenance.
•
ONLY connect this product to a grounded and protected circuit.
•
DISCONNECT from power before cleaning or replacing the fuse.
•
DO NOT look at the light source when the product is on.
•
Make sure the power cord is not crimped or damaged.
•
Never disconnect this product from power by pulling on the cord.
•
When mounting this product overhead, ALWAYS use a safety cable.
•
DO NOT allow flammable materials close to the product when it is operating.
•
DO NOT touch the product's housing when it is on because it will be hot.
•
The voltage of the outlet to which you are connecting this product must be within the range stated
on the decal or rear panel of the product.
•
This product is for indoor use only! (IP20) To prevent risk of fire or shock, do not expose this
product to rain or moisture.
•
Always mount this product in a location with adequate ventilation, at least 20 in (50 cm) from
adjacent surfaces.
•
Be sure that no ventilation slots on the unit's housing are blocked.
•
Never connect this product to a dimmer or rheostat.
•
Replace the fuse with the same type and rating.
•
Never carry the product by the power cord. Use only the handle to carry this product.
•
The maximum ambient temperature is 104 °F (40 °C). Do not operate this product at higher
temperatures.
•
In the event of a serious operating problem, stop using immediately.
•
DO NOT open this product. It contains no user-serviceable parts.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Contact
Outside the U.S., United Kingdom, Ireland, Mexico, or Benelux, contact your distributor to request support or return a
product. Visit
www.chauvetdj.com
What is Included
•
Intimidator Beam 140SR
•
Power Cord
•
Hanging Bracket
•
Warranty Card
•
Quick Reference Guide
To Begin
Unpack your Intimidator Beam 140SR and make sure you have received all parts in good condition. If the box or contents
appear damaged, notify the carrier immediately, not Chauvet.
1
QUICK REFERENCE GUIDE
for contact information.
www.chauvetdj.com
for more details.
Intimidator Beam 140SR QRG Rev. 6
Publicité
Table des Matières
