Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
CPM
WARNING
Burn hazard on the motor, unit, check
valve, connecting hose/pressure pipe
and from hot oil!
Wear safety gloves!
WARNING
Hearing damage from noise during op-
eration!
Wear ear protection!
WARNING
Damage to the connexion cable!
Protect it from sharp edges, oil and heat!
Grasp the plug and unplug it from the
power outlet!
• Be calm and focused and ensure proper
operation.
• Protect yourself and other persons, ani-
mals, property, and the environment by
taking the necessary protective measures
and being trained in use of the devices to
prevent harm to your health, property
damage,
financial
harm or risk of accident.
• Repairs may be carried out only by Schnei-
der Druckluft GmbH or its approved service
partners.
• Observe the Instruction Manual for ves-
sels!
• Prohibited: Manipulations, use for pur-
posed other than those intended; tempo-
rary repairs; compressing other energy
sources; removing or damaging safety
equipment; use in case of leaks or mal-
functions; not using original spare parts;
exceeding the specified permitted final
compression pressure; working without
safety equipment; transporting the unit,
maintaining it, repairing it or leaving it un-
supervised while pressurised; using other/
incorrect lubricants; smoking; open flame;
removing stickers.
• Prohibited: Letting off compressed air via
the condensate drain valve; suspending
the equipment from crane cables using un-
suitable load-bearing points; climbing on
machine parts, or using machine parts to
help you climb up.
II/8
loss,
environmental
2.4 Commissioning
2.4.1
Transport
• Vessel depressurised.
• In the vehicle: Transport the compressor in
an upright position on its feet and wheels,
secure it and protect it.
• With crane: Suitable lifting gear can be at-
tached to the compressor at suitable load-
bearing points on the frame (item 21).
It is important to take into account the
centre of gravity so that the machine does
not tilt or tip over.
The guard bar (item 22) is not suitable for
bearing loads.
Neither the adaptor plate accessory for
attaching Systainers nor any Systainers
attached to it are suitable for bearing
loads.
2.4.2
Conditions at the installation lo-
cation
• Rooms: as dust-free as possible, dry, well
ventilated.
• Outside: Protect the machine from frost,
direct sunlight, dust, rain and splashes of
water.
• Installation surface: flat, horizontal.
• Make sure that the machine is accessible
and adequately lit.
• Keep heat dissipating devices and lines
away from the compressor.
2.4.3
Before first use
1. Carry out a visual inspection.
2. Check the electrical connection.
3. Check the oil level (see Chap. 2.6.6).
For units with attached oil dipstick, re-
place with sealing plug in unit and fill with
oil.
2.4.4
Electrical connection
• The mains voltage must match that speci-
fied on the rating plate.
• Electric protection according to technical
data.
When using extension cords: cable cross-
section:
min.
length:10 m.
2.4.5
Checking/changing the rotation
direction
For three-phase compressors:
1. Check the rotation direction each time
the power plug is plugged in: switch on
the compressor, observe it and switch it
2.5 mm²;
max.
cable
Publicité
Table des Matières
