Before First Use; Compressor Inspections - Schneider Airsystems UNM 260-10-50W Notice D'utilisation D'origine

GB
UNM 260-10-50 W
09 Condensate drain valve
10 Pressure switch with ON/OFF switch
11 Safety valve
12 Pressure gauge (vessel pressure)
13 Pressure gauge (working pressure)
14 Electric motor
18 Filter pressure reducer
19 Quick-action coupling (clean, regu-
lated compressed air)
1.6 Commissioning

1.6.1 Before first use

Replace the sealing plug with the oil dip-
stick (item 03) and fill with compressor
oil. For oil quantity, see "Technical data"
chapter.
1.7

Compressor inspections

This compressor is subject to a type approval
inspection. As a result, inspections by an au-
I/4
All manuals and user guides at all-guides.com
thorised expert prior to commissioning are
no longer necessary. The prototype identi-
fication code is located on the compressor
specification plate.
We recommend that a "qualified person"
perform a pressure test on the vessel after
10 years, depending on general levels of
wear and tear.
A "qualified person" should be well informed
about Ordinance on Industrial Safety and
Health (formerly authorised expert)
Contact any of our approved service part-
ners. Most of our service partners have em-
ployees with expert qualifications.
The papers accompanying the vessel are
approval documents and must be kept
throughout the service life of the vessel.
These specifications only apply in Germa-
ny. Equivalent regulations apply in other
countries.