Dolmar HT-2145 D Manuel D'instructions page 4

Starting up the Hedge Trimmer
– Please make sure that there are children or other people within a
working range of 50 feet or 15 meters (5), also pay attention to
any animals in the working vicinity
– Before operating, always check that the Hedge
Trimmer is safe for operation:
Check the security of the throttle lever. The throttle lever should be
checked for smooth and easy action. Check for proper functioning
of the throttle lever lock. Check for clean and dry handles and test
the function of the STOP switch. Keep handles free of oil and fuel.
Start the Hedge Trimmer only in accordance with the instructions.
Do not use any other methods for starting the engine (6)!
– Use the Hedge Trimmer only for applications specified.
– Start the Hedge Trimmer engine only after the entire assembly is
done. Operation of the Hedge Trimmer is permitted only after all
the appropriate accessories are attached!
– Before starting, make sure that the cutter blade will not contact
any objects such as branches, stones, etc.
– The engine is to be stopped immediately if there are any engine
problems.
– When working with the Hedge Trimmer, keep both hands on
handles always wrap your fingers tightly around the handle,
keeping the control handle cradled between your thumb and
forefinger. Keep your hand in this position to have your machine
under control at all times. Make sure your control handle is in
good condition and free of moisture, pitch, oil or grease.
Always ensure a safe, well-balanced footing
– Only use outdoors.
– Operate the Hedge Trimmer in such a manner as to avoid
inhalation of the exhaust gases. Never run the engine in enclosed
rooms (risk of suffocation and gas poisoning). Carbon monoxide is
an odorless gas. Always ensure there is adequate ventilation.
– Stop the engine when resting and when leaving the Hedge Trimmer
unattended. Place it in a safe location to prevent danger to others,
setting fire to combustible materials or damage to the machine.
– Never lay down the hot Hedge Trimmer onto dry grass or onto
any combustible materials.
– Never operate the engine with a faulty exhaust muffler.
– Stop the engine during transport (7).
– Secure the tool properly before transporting in vehicle to avoid
fuel leakage.
– When transporting the Hedge Trimmer ensure that the fuel tank is
completely empty to avoid fuel leakage.
Refuelling
– To reduce the risk of fire and burn injury; handle fuel with care.
It is highly flammable.
– Stop the engine before refuelling (7), keep well away from open
flame (8) and do not smoke.
– Do not attempt to refuel a hot or a running engine.
– Avoid skin contact with petroleum products. Do not inhale fuel
vapor. Always wear protective gloves during refuelling.
Change and clean protective clothing at regular intervals.
– Take care not to spill either fuel or oil always wipe unit dry before
starting engine. Allow wet cloths to dry before disposing in
proper, covered container to prevent spontaneous combustion.
– Avoid any fuel contact with your clothing. Change your clothing
immediately if fuel has been spilled on it (danger hazard).
– Inspect the fuel cap at regular intervals making sure that it stays
securely fastened.
– Carefully tighten the locking screw of the fuel tank. Move at lease
10 ft (3 meters) away from the refuelling point before starting
engine.
– Never refuel in closed rooms.
ground level (risk of explosions).
– Only transport and store fuel in approved containers. Make sure
stored fuel is not accessible to children.
– When mixing gasoline with two-cycle engine oil, use only gasoline
which contains no ethanol or methanol (types of alcohol).
This will help to prevent damage to fuel lines and other engine
parts.
– Make sure the unit is properly assembled and in good operating
condition.
4
Fuel vapors accumulate at
(5)
(6)
• Resting
• Transporting
• Refuelling
• Maintenance
• Tool Replacement
(7)
(8)
(9)