Risk Of Injury - Abicor Binzel ABIROB A 300 Mode D'emploi

®
ABIROB A
9.1 Cleaning the wire guide
1 Unscrew the cable assembly on the machine side and lay it out in a stretched position.
2 Unscrew the nut and pull out the spiral liner or PA liner.
WARNING

Risk of injury

Serious injuries may be caused by parts swirling around.
• When cleaning with compressed air, wear suitable protective clothing, in particular safety
goggles.
3 Clean the wire conduit from both sides with compressed air.
4 Slide the adjusted spiral liner or PA liner into the wire conduit and secure with a nut.
9.2 Shortening the spiral liner
NOTICE
• New and unused spiral liners or PA liners must be shortened to the actual length of the
cable assembly.
1
Retaining sleeve
2 Central connector
Fig. 7
1 Lay out the cable assembly (3) in a stretched position.
2 Disconnect the central connector (2) from the feed unit.
3 Screw on the retaining sleeve (1).
4 Replace the old spiral liner (6) with a new one and insert the stripped side into the central
connector (2).
1
6
5
3
Cable assembly
4 Nut
Shortening the spiral liner
9 Maintenance and cleaning
2 3
4
5
Collet
6 Spiral liner
EN - 19