Stability; Use And Moving - hymer 8473 Instructions De Montage Et D'utilisation

9.

Stability

WARNING!
Risk of injury.
Never leave the product unattended. Ensure that unauthorised
persons cannot climb on the mobile tower.
these assembly and use instructions.
If assembly is carried out on one side against a wall, do not dis-
pense with the stabilisers on the wall side (if provided).
Warning: Horizontal and vertical loads may cause the product to tip
over, such as:
horizontal loads (when working on adjacent structures, etc.)
additional wind loads (tunnel effect from passageways between
buildings, unclad buildings and building corners)

10. Use and moving

10.1 Use
Comply with national and local regulations when using the product.
Take adequate precautions against possible environmental factors
that may impair safe working on the product.
The danger zone is the area around the product where people can
the entire product.
If possible, lock doors and windows in the area of application.
Do not use the product in snow, freezing rain, heavy rain or thun-
derstorms.
Hand over tools and materials from platform to platform. Do not
throw them.
Always keep access hatches closed before and after climbing
through them.
Do not overload the platform.
Always distribute load evenly on the platform.
10.2 Preparations for moving
10.2.1 With stabilisers for erection on one side against a wall:
Moving the product is not permitted if the assembly combination
requires ballasting and/or load-distribution pads according to the
assembly and use instructions.
Moving the product is only permitted if the product requires no
ballasting or load-distribution pads according to the assembly and
use instructions.
10.2.2 With stabilisers and castors with struts:
10.2.3 With stabilisers and castor without struts:
Products with no castor struts must be dismantled before moving to
the lowest height requiring a stabiliser.
2021-08 0095853 8473 TNR
Rocking movements that cause the mobile tower to vibrate are not
permitted.
Stability is no longer guaranteed at wind speeds of over 12 m/s.
The product must be dismantled or moved to a wind-protected
area beforehand; do not access the product at wind speeds of over
12 m/s as it poses a danger to the surrounding area. Additional wind
loads (tunnel effect from passageways between buildings, unclad
buildings and building corners).
If the user leaves the place of use, the product must be disman-
tled, moved to an area protected from the wind or secured against
tipping over or rolling away by additional suitable devices.
bly and use instructions.
Observe the following before every use:
Check the vertical alignment of the product and correct as
Lock the brakes on the castors (red lever underneath).
Check the effectiveness of the locks.
Dismantle large assembly combinations as low as required and
remove the ballast.
Only release the castor brakes after the struts have been adjusted.
Dismantling (to the lowest height requiring a stabiliser) is not neces-
sary if the tower is moved indoors.
15
EN 1004-2 – en