Ant-Eu Remote Antenna; Bgsm-100Ba Or Bgsm-120Ba - Bentel Security BGSM-100KCA Mode D'emploi

6. Complete the connections on the terminal blocks [10].
7. Following the arrow, insert the SIM-CARD [8] face down in the SIM holder [6] (see Figure 1).
! ! ! ! !
The SIM-CARD PIN must be disabled before the card is inserted into the Communicator.
8. Make sure that all the green LEDs flash when the product is switched on; this means the Communicator is in its initialisation phase.
9. Checking Signal Strenght :
– make sure that at least one of the green LEDs remains lit; all green LEDs lit indicates optimal coverage;
– if the green LEDs are not illuminated, the signal strength is TOO WEAK; change the position of the antenna until you
find a position which offers acceptable signal strength, at least one LED illuminated.
10. Close the control panel cover.
, , , , , Connect power circuit only after the cabinet has been secured to the building or structure and has been
connected to the protective earth ground of the building.
! ! ! ! !
Before inserting or removing the SIM card, please ensure the unit is powered down.

ANT-EU Remote antenna

For details of how to fit the remote ANT-EU outdoor antenna, please refer to the instructions supplied with the product. The
ANT-EU is used to provide the Communicator a excellent GSM signal strength.

BGSM-100BA or BGSM-120BA

See figure 1.
1. Mark the position of the holes [19] required to fix the metal base [17] to the wall.
2. Drill holes in the wall as marked.
3. Insert the 4 P.C.B. supports [16] into the holes on the metal base [27].
4. Feed the connection cables through the opening on the base [22].
5. Fix the metal base to the wall using wall anchors (not supplied).
! ! ! ! !
Make sure you do not damage
wiring or pipes in the chase.
Fig. 2 - Mounting of electronic card inside the control panel.
30
GSM/GPRS Alarm Communicators