Options; Dial Options; Event Priority (Bgsm-120 Series Only); Codes (Bgsm-120 Series Only) - Bentel Security BGSM-100KCA Mode D'emploi

White List
…
…
;

Options

This page is used to set the options relating to the Communicator board.

Dial options

This part is used to enter some of the characteristics relating to the telephone numbers used.
† Prefix: This Device will prefix the digits entered in this field to all the telephone numbers dialled through the GSM Interface
function. If necessary enter a Prefix (maximum 8 digits) in this field. If no Prefix is required, leave this field empty.
† Digits to Remove: If this Communicator is connected downstream to a switchboard, the telephone numbers (programmed
on the Control panel) must be preceded by the switchboard number (normally one digit). As the switchboard number is
not required when calls are sent over the GSM Network, it must be removed from the digits which form the telephone
number. Enter the number of digits that form the switchboard number (e.g. if switchboard number is 01, enter 2 in the
"Digits to remove" field, as 2 numbers form the switchboard number).
, , , , , The telephone number should at least have two digits more that the number in the "Digits to remove" area,
otherwise the engaged tone will be come through, e.g.:
– the dialled telephone number is 0123, with 2 digits to be removed = correct, the remaining number to be inserted is 23.
– the dialled telephone number is 123, with 2 digits to be removed = engaged tone, the remaining number
to be inserted is 3.
† Enable Black List: Check this box if you do not wish to receive calls from stored telephone numbers, authorising only
the numbers selected previously using the White List function (Phonebook page->White List).
, , , , , Only the "Black List" option cancels the call immediately.
, , , , , When the "Black List" and "Activates Output" options are enabled, there is a delay (some seconds) before
the call is cancelled;
When the Ring is selected for the Activation Confirmation option, there is a delay (some seconds) before the
call is cancelled;
The output will be not activated when the call is canceled.

Event priority (BGSM-120 series only)

This page may be used to program several Communicator priorities, for the transmission of alarm events (see Priority
management section).
† Off-Hook: This box can be used to establish the priority of telephone devices connected to the LI terminals (such as a
burglar alarm control panel). It is enabled ; ; ; ; ; by default; to disable it remove the tick … … … … … .
† Voice Dialer: This box can be used to establish Voice dialer (voice message) priority. It is disabled … … … … … by default; to
enable it, mark it with a tick ; ; ; ; ; .

Codes (BGSM-120 series only)

† User Code: Enter the account code in this box (maximum 4 numeric characters) to activate outputs remotely. For further
information, please refer to the section "Activating the Outputs->Remote Activation and Deactivation of the
Outputs": The default code is set to '0001'.
† Installer Code: The Installer code can be entered in this field (maximum 4 numerical characters). This code allows
access to the "Web Service" interface when required. The default code is set to '0002'.

Generic

This section may be used to set the audio levels of the loudspeaker and microphone fitted to the GSM Communicator.
† Speaker volume: The volume of the loudspeaker may be adjusted by shifting the cursor.
† Microphone volume: The volume of the microphone may be adjusted by shifting the cursor.
† Tones...: Select the name of Communicator's country of installation; the selected country will establish a series of
parameters for the proper working of the simulated telephone call.
42
Black List
…
Accept incoming calls from any number
;
Refuse any incoming call
Accept incoming calls only from numbers having an enabled
;
White List option, refuse call coming from all other numbers
Functioning mode
GSM/GPRS Alarm Communicators