Remote Programming (Bgsm-120 Series Only); Changing The User Code; Web Service; Changing The Installer Code - Bentel Security BGSM-100KCA Mode D'emploi

, , , , , Remove the "TonU" parameter, leaving the "##" characters, to activate the output by SMS as programmed.
2. Through caller identification: in this case the output is activated at "cost-free" as the Communicator, after identifying
the caller, rejects the call and activates the output.
, , , , , Monostable OC outputs deactivate (switch OFF) automatically when the programmed ON Time expires.
, , , , , The default User code is '0001'; if you wish to change it, please refer to the section "Remote programming->Changing
the User code".

REMOTE PROGRAMMING (BGSM-120 series only)

In addition to the processes described in the section Remote activation and deactivation of the outputs, it is also
possible to carry out other remote procedures through the transmission of various SMS messages.

Changing the user code

The default user code is '0001'; to change it, send an SMS message consisting of the characters "#CUC" followed by the
old User code and the new User code between * characters, in accordance with the following formula:
, , , , , The User code may only consist of numbers from 0 to 9 (maximum 4 digits).

Web service

The Web service can be enabled using the BGSM-120 Console software (please refer to section Programming via PC-
>GPRS->Web service), or by sending an SMS message consisting of the characters "#UWS" followed by the User code
and "ON" between * characters, in accordance with the following formula:
To disable the Web service, send the following SMS message:

Changing the Installer code

The Installer code (maximum 4 numeric characters) is used in the event that the Web service needs to be accessed (see
section Programming via PC->Codes->Installer code). The default istaller code is '0002'; to change it, send an SMS
message consisting of the characters "#CIC" followed by the old Installer code and the new Installer code between *
characters, in accordance with the following formula:
, , , , , The Installer code may only consist of numbers from 0 to 9 (maximum 4 digits).

Credit balance check

To find out the credit balance via SMS, you can either use the BGSM-120 Console software (see section Programming via
PC->Options->Pay As You Go), or you can find out remotely by sending an SMS message consisting of the characters
"#CCC" followed by the * character, in accordance with the following formula:
, , , , , The pre-paid SIM CARD credit management service may be suspended at any time, at the discretion of each
individual GSM network operator.
BGSM-100/120
(example: #9876#HOUSELIGHT=ON##)
#CUC*User code*New User code*
#UWS*User code*ON*
#UWS*User code*OFF*
#CIC*Installer code*New installer code*
#CCC*
G G
G G G
39