Adjusting Airflow Direction
This section is described in the instruction manual supplied with the timer remote contoller (CZ-RTC2).
Regarding the High-spec Wired Remote Controller (CZ-RTC3), refer to the Operating Instructions supplied with the model CZ-RTC3.
Adjusting the upward and downward motion of airflow direction (U1 and T2 types only)
Using the timer remote controller
"FLAP" button
Using the wireless remote controller
Adjusting the horizontal airflow direction
(Manual: T2 type only)
6
Airflow direction
display
Airflow direction display
"FLAP" button
Move the horizontal airflow vanes
by hand for adjustment.
Press
/
Recommended vertical airflow direction
Set the flap to the downward position for heating operation.
z
(With the upward setting, warm air cannot reach the floor.)
Set the flap to the upward position for cooling operation.
z
(With the downward setting, condensation may drip on to the
floor.)
U1, T2 type
HEAT
Recommended
to select your desired airflow direction.
Flap swing motion
Pressing the button during
z
swing operation can stop the
flap at the desired position.
Display when swing operation
is stopped
Fan and
Cooling and
heating
drying
(5 levels)
(3 levels)
Flap fixed (5 levels)
COOL / DRY
FAN
Fixed to this
position
Recommended