Stealth Cam STC-G45NGX Manuel D'instructions page 15

!
CAMERA NAME – STEALTH CAM (default): This setting is used to identify the camera on the
Info Bar. It can be up to 13 characters long in the form of alpha (A-­‐Z), numeric (0-­‐9), or
spaces. With this option blinking, use the UP or DOWN arrow buttons to change the initial
character. Once the blinking character has been changed, use the RIGHT arrow button to
continue to the next character. Repeat until the desired name is entered. When finished
press the ENTER button again to confirm and store the new camera name. Pressing the
DOWN arrow key will move the display to the next configuration option.
!
TEMPERATURE – FAHRENHEIT (default): This setting is used to tell camera if the
temperature reading on the Info Bar should be in Fahrenheit or Celsius. With this option
blinking, pressing the UP or DOWN arrow buttons will cause the camera to cycle between
the two options.
!
INFO BAR – ON (default): This setting is used to tell camera if the Info Bar should be
displayed at the bottom of images and video or not. With this option blinking, pressing the
UP or DOWN arrow buttons will cause the camera to cycle between the two options of ON
or OFF.
!
DVR MODE – OFF (default): This setting allows you to perform loop recordings. When
turned ON, this mode will allow the camera to overwrite the earliest recorded files when the
SD card reaches full capacity. When turned OFF, the camera is not allowed to write over
existing files. Once SD card is full the camera stops recording.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
15
Page