Stealth Cam STC-G45NGX Manuel D'instructions page 11

o
PIR PHOTO (default): In this mode the camera will take a designated amount of picture with a designated time
out when the camera senses activity in front of the unit. This mode is available for both day and night activities.
" PHOTO RES – 8.0 MP (default): This setting is used to determine the Megapixel resolution of each image
taken by the camera. With this option blinking, use the UP or DOWN arrow key to move between the
options of: 22MP, 16MP, 8MP or 4MP. The higher the resolution of an image the more space the file will
take on the SD memory card.
"
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the
camera will wait before it reinitializes its PIR sensor for the next activation. With the TL mode this setting
is only active if TL Delay is set to 1 min or greater. This setting can be changed between the numbers of
00min 05sec to 59min 59sec. With this option blinking, use of the UP and DOWN arrows will allow
the minutes setting to be changed from 00 to 59. Once this setting is on the appropriate minutes,
press the RIGHT arrow key to move to the seconds setting and it will start to blink. Use of the UP and
Down arrows will allow the seconds setting to be changed from 00 to 59 (05 to 59 if minutes = 00).
"
PIR RANGE – STANDARD (default): This setting allows you to control the sensitivity distance the PIR will be
activated. These distances can vary depending on environmental conditions. This setting will change
between EXTENDED which will trigger about 1/3 further than the STANDARD setting, the STANDARD
setting, or NEAR FIELD that will only trigger on movement closest to the camera.
" REDUCE BLUR – ADVANCED (default): This setting is used to determine if the camera should use the
MATRIX Blur reduction technology to dramatically reduce the blur effect resulting in clearer night time
infrared shots. (STANDARD) Minimizes blurring effect in images whlle retaining long* range night
image capability. (ADVANCED) Maximum blur reduction achieved through a faster shutter speed. This
setting my cause a slight reduction in night time range and increased grain in the image. With this option
blinking, pressing the UP or DOWN arrow buttons will cause the camera to cycle between the two options
of STANDARD or ADVANCED.
"
PHOTO BURST – 1 PHOTO (default): This setting is used to determine the number of photos the
camera will take during its activation. This setting can be changed between 1 PHOTO up to 9
PHOTOS. With this option blinking, use the UP or DOWN arrow key to move between the value
range in increments of 1.
IR Brightness Control – FULL (default): This setting is used to adjust the brightness of the IR LEDS. With this
"
option blinking, use the UP or DOWN arrow key to move between FULL and HALF brightness. On FULL
brightness the LEDs have a further flash range making it ideal for large open areas. HALF brightness is ideal
for close up shots preventing the subject from being overexposed.
SMART IR - ON (default): This setting is used to to toggle Smart IR ON and OFF. With this option blinking,
"
use the UP or DOWN arrow to move between ON and OFF. While enabled the camera will take color
images during the dusk and dawn lighting conditions. While Smart IR is ON, Photo Burst is limited to (1)
image per triggering.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
11
Page