Stealth Cam STC-G45NGX Manuel D'instructions page 13

o
TIME LAPSE (TL): In this mode the camera will take a designated amount of pictures with a
designated time out between the designated hours of operation even if there is no activity in
front of the camera.
PHOTO RES – 8.0 MP (default): This setting is used to determine the Megapixel resolution of each image taken
"
by the camera. With this option blinking, use the UP or DOWN arrow key to move between the options of:
22MP, 16MP, 8MP or 4MP. The higher the resolution of an image the more space the file will take on the SD
memory card.
"
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the camera will
wait before it reinitializes its PIR sensor for the next activation. With the TL mode this setting is only active if TL
Delay is set to 1 min or greater. This setting can be changed between the numbers of 00min 05sec to 59min
59sec. With this option blinking, use of the UP and DOWN arrows will allow the minutes setting to be changed
from 00 to 59. Once this setting is on the appropriate minutes, press the RIGHT arrow key to move to the
seconds setting and it will start to blink. Use of the UP and Down arrows will allow the seconds setting to be
changed from 05 to 59 (05 to 59 if minutes = 00).
"
PIR RANGE – STANDARD (default): This setting allows you to control the sensitivity distance the PIR will be
activated. These distances can vary depending on environmental conditions. This setting will change
between EXTENDED which will trigger about 1/3 further than the STANDARD setting, the STANDARD setting, or
NEAR FIELD that will only trigger on movement closest to the camera.
SMART IR - ON (default): This setting is used to to toggle Smart IR ON and OFF. With this option blinking, use the
"
UP or DOWN arrow to move between ON and OFF. While enabled the camera will take color images during the
dusk and dawn lighting conditions. While Smart IR is ON, Photo Burst is limited to (1) image per triggering.
"
TL DELAY – 00min 30sec (default): This setting is used to set a delay between TIME LAPSE images. This
setting can be changed between the numbers of 00min 05sec to 59min 59sec. With this option blinking, use of
the UP and DOWN arrows will allow the minutes setting to be changed from 00 to 59. Once this setting is on the
appropriate minutes, press the RIGHT arrow key to move to the seconds setting and it will start to blink. Use of
the UP and Down arrows will allow the seconds setting to be changed from 00 to 59 (05 to 59 if minutes = 00). If
the TL Delay is greater than or equal to 1 min, then the PIR sensor will be active between time-lapse photos.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
13
Page