Little Giant Climb On M13 Consignes De Fonctionnement/Sécurité page 58

STANDOFF MODE:
1. Before setting ladder up, install arms to horizontal
track, extending out sides of ladder (Fig. A).
2. Use extension locks to extend arms to desired width
(Fig. B).
3. Rotate wall pads 90-degrees into use position (Fig. C).
4. Make sure spring pins and extension locks are fully
locked before setting up ladder as described on
ladder's labels (Fig. D).
A. Install arms
TOOL HOOKS
MAX. LOAD
15 lb [6.8 kg]
MAINTENANCE:
Little Giant Limited 1-Year Warranty Terms and Conditions
Little Giant Ladder Systems warrants each new product to the original purchaser thereof, to be free from defects in workmanship and materials
when operated under normal conditions and maintained properly. This warranty covers all parts of the product, and shall be in lieu of any other
warranty, expressed or implied, including, but not limited to, any implied warranty of merchantability or fitness for a particular purpose.
In the unlikely event that within the warranty period from the date of the original purchase, there is a problem caused by defects in either
workmanship or materials, Little Giant Ladder Systems will repair or replace, at its option and without cost to the original purchaser. All freight to
and from the factory is to be paid by the customer. If a replacement is necessary and your product is no longer available, a comparable product
will be substituted.
The liability of Little Giant Ladder Systems under this warranty shall be limited solely to the repair or replacement of the product within the warranty
period. Little Giant Ladder Systems shall not be liable, under any circumstances, for consequential or incidental damages, including, but not
limited to, personal injury or labor costs. Some states do not allow the exclusion of incidental or consequential damages, so the above limitations
or exclusions may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state.
Under no circumstances will Little Giant Ladder Systems be responsible for any expense in connection with any repairs made by anyone other
than the factory or authorized service provider, unless such repairs have been specifically authorized in writing by Little Giant Ladder Systems.
This warranty applies only to North America. Manufacturing specifications are subject to change without notice.
LITTLE GIANT® SAFETY RAILS™ may be protected by one or
more U.S. or international patents, and/or may have additional
patents pending. Visit www.LittleGiantLadders.com/patents
for details. This web page is provided in compliance with the
virtual patent marking provisions of the America Invents Act.
USER INSTRUCTIONS (CONTINUED)
B. Extend to
desired length
Approved hang zone
1. Keep SAFETY RAILS clean.
2. Keep in storage position attached to ladder when not in use.
3. Store where dry and protected from unsafe materials, impact, or corrosion damage.
4. Lubricate with a dry lubricant at least every six months, and prior to long term storage, or more often as use
dictates, and under extreme weather conditions. Wipe off any excess with a clean, dry rag.
LITTLE GIANT LADDER SYSTEMS
1198 North Spring Creek Place / Springville, UT, USA 84663
��: 1-800-453-1192 /
To unlock:
Press and hold
SPRING PINS
C. Rotate wall
pads in
: www.LittleGiantLadders.com
83430 v0 5.19 ENG
To lock:
Release
D. Set ladder up
WARNING
Do not over-reach when using SAFETY
RAILS in this mode. Keep body centered
between ladder side rails. When hanging
tools from SAFETY RAILS, keep inside
approved hang zone and never exceed
15 lb [6.8 kg] per arm. Little Giant Ladder
Systems is not liable for any damage or
injury that may occur from falling items.
LITTLE GIANT is a registered trademark of Wing
Enterprises, Inc. in the United States and Canada.
SAFETY RAILS is a trademark of Wing Enterprises, Inc.
MADE IN CHINA
™
!
Scan QR code to view
safety/instructional video