Comfort Step™ Platform Instructions; Ratchet™ Leveler Instructions - Little Giant Climb On M13 Consignes De Fonctionnement/Sécurité

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

K. COMFORT STEP™ Platform Instructions
Note: Depending on your ladder model, the COMFORT STEP platform may or may not be
included or available. If your ladder is equipped with the COMFORT STEP platform, it will
also be equipped with the accessory ports.
EN
1. If your ladder is equipped with the COMFORT STEP platform, it will automatically deploy
into its in-use position when the ladder is opened from the storage position to the
stepladder mode.
2. To store the platform, pull up and inward on the rubber handle as you close the ladder into
its storage position (Fig. 58-59).
3. When reassembling the ladder after using it in the scaffolding trestle mode, if your ladder
has TIP & GLIDE™ wheels, the outer ladder assembly with the wheels should be
installed on the inner ladder half opposite of the COMFORT STEP platform.
WARNING:
STEPLADDER OR STAIRCASE MODE WITHOUT THE AIRDECK WORKSTATION IN THE
SAFETY HANDRAIL POSITION. NEVER STAND ON THE PLATFORM IN THE 90-DEGREE
MODE. WHEN SETTING THE LADDER UP IN THE STRAIGHT LADDER MODE, MAKE
SURE THE PLATFORM IS ON THE LOWER HALF OF THE LADDER.
L. RATCHET™ Leveler Instructions
Note: Depending on your ladder model, the RATCHET levelers may or may not be
included or available, or may be one of two styles: D-ring release or slider release.
1. To deploy the RATCHET levelers, on uneven surfaces, look for the ladder foot that is not
touching the ground while holding your ladder with the rungs level, then press down on
the kick plate of that RATCHET leveler leg with your toe until its foot contacts the ground
(Fig. 60 or 62). Spring-loaded pins will lock the leg in position approximately every 7/16"
[11 mm] up to the maximum length of the leg, which may vary by model.
2. To retract the RATCHET levelers, after you are off the ladder, pull out on the D-rings
(Fig. 61) or pull up on the slider (Fig. 63) and the RATCHET leveler legs will return to their
storage position.
TO DEPLOY
16
NEVER STAND ON THE COMFORT
TO RETRACT
60
D-ring release
58
TO DEPLOY
61
59
STEP PLATFORM IN THE
TO RETRACT
62
Slider release
63

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Climb on m17Climb on m22Climb on m26

Table des Matières