Little Giant Climb On M13 Consignes De Fonctionnement/Sécurité page 57

Tracks
(lock holes)
Wall pad
Spring pins
Extension
lock
Main lock
handle
Tool hook
(Storage Mode)
INSTALLATION:
1. Squeeze and hold main lock handle to retract locking pin.
2. Slide SAFETY RAILS arm on track and into desired position (walk-
through, standoff or storage).
3. Release handle and slide arm into position until pin fully locks inside
hole.
WARNING
WALKTHROUGH MODE:
1. With ladder in its straight ladder mode and laid on
ground, install arms to siderail tracks, extending
past top of ladder. NOTE: Slide arms onto track
at end away from ladder's feet (Fig. A).
2. Use extension locks to extend arms until they are
fully extended (Fig. B).
3. Make sure main lock handles and extension
locks are fully locked before use. Main lock
handle alignment can be confirmed with labels
on ladder's rail (Fig. C).
4. Set ladder up as described on ladder's labels, but
with top rung at or just below top support point
(Fig. D).
5. Grip SAFETY RAILS firmly as you reach top
of ladder, and as you step through onto roof or
elevated platform.
6. When remounting ladder from above, hold
SAFETY RAILS and turn to face ladder before
descending.
IMPORTANT: To remove arms from walkthrough mode,
you must lift up slightly to disengage safety lock
feature before unlocking main lock handles.
USER INSTRUCTIONS
Make sure arms are fully locked before
use. Never attempt to adjust or reposition
SAFETY RAILS while in use. Only use
SAFETY RAILS on LITTLE GIANT ladders
with factory-installed tracks.
To unlock:
Press and hold
Pin retracts
A. Slide on
toward foot
Read and follow all instructions on SAFETY RAILS and on ladder.
FAILURE TO DO SO COULD RESULT IN INJURY OR DEATH.
(Walkthrough Mode)
Squeeze and hold
To lock:
Release
Pin engages
EXTENSION LOCKS
B. Fully
extend
DANGER
(Standoff Mode)
To unlock: To lock:
Release
Pin retracts Pin engages
MAIN LOCK HANDLES
WARNING
Never lean ladder with SAFETY RAILS
contacting wall in this mode. Do not
stand on top two rungs without SAFETY
RAILS arms installed in walkthrough
mode, and never work from top two rungs.
YOU CAN LOSE YOUR BALANCE.
SAFETY RAILS are for stability only. Do not
lean, push or pull on them, which can cause
ladder to move.
C. Confirm lock alignment
™
!
Scan QR code to view
safety/instructional video
Top
support
point
D. Set top rung at
or just below top
support point