Regulation of the Brightness at the Workplace
Switching the lamp
On/Off automatically*
Setting the set value of
the brightness control
Motion Detector
Switching the lamp
On/Off automatically*
Switching off via button,
switching on via motion
detection*
Holiday Control*
* Mode-dependent
If the daylight is sufficient as source of light, the light controller
switches the lamp off. The switching off takes place with a delay of
approx. 1.5 minutes.
If the light value at the workplace falls below the set value and
persons are present, the light controller switches the lamp on again
and regulates the brightness.
1. Alter the brightness to the
desired level with a long press
of the button.
2. P ressthebuttonbriefly
2 times within 30 s after setting
the set value.
If the motion detector does not detect any movement for 15 minutes,
the light controller reduces the brightness to a minimum and then
switches the lamp off. The next detected movement switches the
lamp on again, insofar as artificial light is required.
If the lamp has been switched off at the button, automatic switching
on via the motion detector is only possible again after expiry of a
pause of 30 s without movement. That means, only if no further mo-
vement has been detected for at least 30 s, does the next movement
switch the lamp on, insofar as artificial light is required.
Automatic switching on of the lamp via the motion detector can be
deactivated for a longer absence.
For this the lamp must be switched on. The brightness must not
be changed manually for 30 seconds before the holiday control is
activated.
Pressthebuttonbriefly
2 times.
The brightness changes.
After the button is released the
intensity of the lamp remains
constant.
The set brightness is saved as
new set value.
A double flashing of the lamp
confirms the saving.
The brightness is reduced to a
minimum and the lamp is then
switched off.
The motion detection is deac-
tivated until the next time it is
switched on via the button.
13