Grundig MS240 Mode D'emploi page 17

SET-UP­AND­SAFETY
Please note the following instructions when set-
ting up the system:
The hi-fi system is designed for the playback
7
of audio signals. Any other use is expressly
prohibited.
If you want to set up the hi-fi system on wall
7
shelves or in cupboards, please ensure that it
is adequately ventilated. There must be at least
10 cm of space at the side, above and behind
the hi-fi system.
Do not cover the hi-fi system with newspapers,
7
table cloths, curtains, etc.
When setting up the hi-fi system, remember
7
that furniture is often coated with various types
of varnish and plastic, which often contain
chemical additives. These additives may cause
corrosion to the feet of the unit. This may leave
stains on the surface of the furniture which can
be difficult or impossible to remove.
If the hi-fi system is exposed to sudden chang-
7
es in temperature, for example when taken
from the cold into a warm room, wait at least
two hours before using it.
The hi-fi system is designed for use in dry
7
rooms. If you do use it outdoors, make sure it
is protected from moisture such as dripping or
splashing water.
Only use the hi-fi system in a moderate climate.
7
Do not place the hi-fi system close to heating
7
units or in direct sunlight, as this will impair
cooling.
Do not place any vessels containing liquids,
7
such as vases, on the hifi system. Do not insert
any foreign objects in the CD compartment.
Do not place any objects such as burning can-
7
dles on the hi-fi system.
Do not open the hi-fi system casing under any
7
circumstances. Warranty claims are excluded
for damage resulting from improper handling.
­-----------------------------------------------------------------------------------------------
Thunderstorms are a danger to all electrical
7
devices. Even if the hi-fi system is switched off,
it can be damaged by a lightning strike to the
mains. Always disconnect the mains plug dur-
ing a storm.
7
Note:
Do not connect any other equipment while
7
the device is switched on. Switch off the oth-
er devices as well before connecting them.
Only plug the device into the mains socket
7
after you have connected the external de-
vices. Make sure the power plug is freely
accessible.
General­information­on­laser­
devices
CLASS 1
LASER PRODUCT
a way as to ensure that the maximum permis-
sible emission value cannot be exceeded under
any circumstances.
Caution:
sions.
This device emits laser radiation. Because of
the danger of eye injuries, the unit may only be
opened or serviced by trained personnel.
If settings other than those stated here are used
or other procedures are carried out, this may
lead to dangerous exposure to radiation.
Excessive sound pressure from
the earphones or headphones
can cause hearing loss.
This device is a CLASS
1 LASER PRODUCT.
This means that the la-
ser is designed in such
If operating devices or
methods other than those
specified here are em-
ployed, it may lead to dan-
gerous exposure to emis-
ENGLISH
17­