Abicor Binzel FES-2 W3 Mode D'emploi page 35

FES-200 W3
• Before performing any maintenance and cleaning work, the necessary safety measures must be
• Maintenance and cleaning work on the fume extraction system may only be carried out in areas with
• Always wear your personal protective equipment when performing maintenance and cleaning work.
• The personal protective equipment includes protective clothing, safety goggles, respirator mask
• Nobody without personal protective equipment may stay near the dust collecting drawer when filling
• It is not allowed to dedust the filter cartridge using compressed air.
NOTICE
• A filter change must be carried out if, after multiple dedusting, a vacuum of >180 mbar is still reached,
• This procedure must be carried out when the system is not in operation.
1 Place the cover on the fume extraction
system
Changing the filter
Fig. 5
Proceed as follows:
 Fig. 2 Functional Description on page EN-9
1 Put the fume extraction system on the floor.
2 Switch off the fume extraction system by actuating the rotary switch (11).
3 After having switched off the fume extraction system, wait (for approx. 1 minute) until the dust has settled
down in the fume extraction system.
4 Unscrew the fastening screws (3) from the cover and lift it off.
5 Place the cover carefully on the fume extraction system so that the filter cartridge points upwards.
6 Press the rotation mechanism carefully downwards.
7 Place the dust collecting bag completely over the filter cartridge (5).
8 Loosen the filter cartridge (5) by turning it to the left (counter-clockwise direction).
CAUTION
taken.
locally filtered forced ventilation.
class P3, protective gloves and safety shoes.
the separated dust into it.
and no other error or reason can be detected.
2 Pull the dust collecting bag over the filter
cartridge
5 Functional Description
3 Loosen the filter cartridge
EN - 13