Installing The Light Kit And Acrylic Shade - Kichler 52 GRACE LED Manuel D'instructions

INSTALLING THE LIGHT KIT AND ACRYLIC SHADE

NOTE: Before continuing installation, confirm that the power is still turned off NOTE: Before continuing installation, confirm that the power is still turned off
at the main circuit breaker or by removing the circuit fuse. Turning the power at the main circuit breaker or by removing the circuit fuse. Turning the power
off using a wall switch is not sufficient to prevent electrical stock. off using a wall switch is not sufficient to prevent electrical stock.
Step 1. Remove one of three screws on the switch housing and keep for later Step 1. Remove one of three screws on the switch housing and keep for later
use, loose the other two (do not remove). (Fig. 21) use, loose the other two (do not remove). (Fig. 21)
Step 2. Hold the light kit close to the switch housing and connect the WHITE Step 2. Hold the light kit close to the switch housing and connect the WHITE
wires from the light kit and fan by pushing the connectors together. Follow wires from the light kit and fan by pushing the connectors together. Follow
the same procedure with the BLACK wires. (Fig. 22) the same procedure with the BLACK wires. (Fig. 22)
Step 3. Tuck the connections neatly into the light kit. Place the two slot holes Step 3. Tuck the connections neatly into the light kit. Place the two slot holes
on the light kit over two (2) screws previously loosened from the switch on the light kit over two (2) screws previously loosened from the switch
housing. Rotate the light kit until it locks in place at he narrow end of the housing. Rotate the light kit until it locks in place at he narrow end of the
key holes. Securely tighten two(2) screws previously loosened and the one key holes. Securely tighten two(2) screws previously loosened and the one
previously removed. (Fig. 22) previously removed. (Fig. 22)
Step 4 Step 4. Secure the acrylic shade to switch housing by twisting in a clockwise . Secure the acrylic shade to switch housing by twisting in a clockwise
direction, twist the acrylic shade gradually until it snaps on to the switch direction, twist the acrylic shade gradually until it snaps on to the switch
housing. Do not over - tighten. (Fig. 23) housing. Do not over - tighten. (Fig. 23)
Switch Housing
Screw
Fig. 21
Switch Housing
Acrylic Shade
Fig. 23
Light Kit
Fig. 22
52" Grace LED | 13