Long Term Storage; Blade Sharpening - Shindaiwa T242 Manuel Du Propriétaire/Utilisateur

Masquer les pouces Voir aussi pour T242:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Long Term Storage

Whenever the unit will not be used for
30 days or longer, use the following
procedures to prepare it for storage:
n Clean external parts thoroughly.
n Drain all the fuel from the fuel tank.
IMPORTANT!
All stored fuels should be stabilized with a
fuel stabilizer such as STA-BIL™, if
oil with fuel stabilizer is not used.

Blade Sharpening

When the cutting edges of the blade
become dull, they can be resharpened with
a few strokes of a file.
In order to keep the blade in balance, all
cutting edges must be sharpened equally.
Shindaiwa Tornado
To sharpen the cutters on a Shindaiwa
Tornado™ Blade, use a 7/3-inch round
file. File the leading edge of each tooth to
a razor edge. The top plate of each tooth
should angle back 30°.
16
CAUTION!
Gasoline stored in the carburetor
for extended periods can cause hard
starting and could also lead to
increased service and maintenance
cost.
n Remove the remaining fuel from the
fuel lines and carburetor.
1. Prime the primer bulb until no more fuel
is passing through.
. Start and run the engine until it
stops running.
3. Repeat steps 1 and  until the engine will
no longer start.
Figure 31
Blade
of a blade. DO NOT alter the contour
of the blade in any way.
Round
File
30°
WARNING!
Sharpen only the cutting teeth
n Remove the spark plug and pour about
1/4 ounce of -cycle mixing oil into the
cylinder through the spark plug hole.
Slowly pull the recoil starter  or 3 times
so oil will evenly coat the interior of the
engine. Reinstall the spark plug.
n Before storing the unit, repair or replace
any worn or damaged parts.
n Remove the air cleaner element from the
carburetor and clean it thoroughly with
soap and water. Let dry and reassemble
the element.
n Store the unit in a clean, dust-free area.
Multiple-tooth Circular Blade
Use a round file to maintain a radius of 0.04
to 0.06" (1 to 1.5 mm) at the base of each
tooth. Cutting edges must be offset equally
on each side.
Figure 32
Round
File

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

T242x

Table des Matières