Fein FMT250QSL Mode D'emploi page 19

OBJ_BUCH-0000000244-001.book Page 19 Friday, December 11, 2015 8:33 AM
Repair and customer service.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Exchangeable parts.
If required, you can change the following
parts yourself:
Clamping screw (FMT250SL (**)), application
tools
Service.
Have maintenance carried out
WARNING
only through qualified person-
nel. Incorrectly mounted leads and compo-
nents can cause serious injuries. Have the
required service carried out only through a
FEIN customer service agent.
The current spare parts list for this power
tool can be found in the Internet at
www.fein.com.
Cleaning.
Prior to any cleaning or main-
WARNING
tenance, disconnect the
power tool from the power supply in order to
avoid accidents.
When using in environments
WARNING
with conductive dust in the
air, such as when cutting metals, this dust
can settle in the interior of the power tool.
This can impair the total insulation of the
Warranty and liability.
The warranty for the product is valid in accordance with the legal regulations in the country
where it is marketed. In addition, FEIN also provides a guarantee in accordance with the FEIN
manufacturer's warranty declaration.
All accessories described or shown in this instruction manual will not be included with your-
power tool.
Environmental protection, disposal.
Packaging, worn out power tools and accessories should be sorted for environmental-friendly
recycling.
power tool. Therefore, regularly blow out the
interior of the power tool from outside via the
ventilation openings with dry, oil-free com-
pressed air; always wear eye protection when
doing this. For additional protection, connect
a ground fault circuit interrupter (GFCI) on the
line side.
Do not attempt to clean
CAUTION
clogged or dirty ventilation
openings of the power tool with pointed
metal objects; use nonmetal tools or objects
if necessary.
Do not use cleaning agents
CAUTION
and solvents that can cause
damage to plastic parts. These include: Gas-
oline, carbon-tetrachloride, chloric solvents,
ammonia and domestic cleaning agents that
contain ammonia.
If the supply cable of this
CAUTION
power tool is damaged, it
must be replaced by a specially prepared cable
available through the FEIN customer service
center.
FMT250SL: For storage of the power tool,
remove the application tool and screw the
clamping screw in to the stop.
en
19