Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Arm Tension Adjustment
• Do not remove screw or loosen screw until it is no longer engaged with the mount. Doing so may cause the display
to fall.
• If screws become loose over time, tighten screws as necessary. Tighten screws to 50 in • lbs (5.6 N.m.) maximum
torque.
If more or less tension is desired in the arm pivot points, do the following:
10
• To increase tension, turn socket screw clockwise with 5 mm allen wrench (I). NOTE: Tighten screws to
50 in • lbs (5.6 N.m.) maximum torque.
• To reduce tension, turn socket screw counter-clockwise with 5 mm allen wrench (I). NOTE: Do not turn more
than half a turn.
WARNING
TENSION SCREW
TENSION SCREWS
17 of 70
All other brand and product names are trademarks or registered trademarks of their respective owners.
ISSUED: 10-30-09 SHEET #: 095-9299-11 03-22-12
© 2012, Peerless Industries, Inc. All rights reserved.
Publicité
Table des Matières
