Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Tighten screws so display brackets are fi rmly attached to display. Do not tighten with excessive force.
Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing
screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
Select the screws from the baffl ed fastener pack that best fi t your display and secure to display following step 3-4
3-3
or 3-5 on page 11.
NOTE: Top and bottom mounting holes must be used for attaching display brackets. Middle holes should also be
used where the fasteners and displays allow.
Verify that all holes are properly aligned, then tighten screws using a phillips screwdriver.
DISPLAY
DISPLAY BRACKETS
CENTER DISPLAY BRACKETS VERTICALLY ON BACK OF DISPLAY
B
NOTE: "X" dimensions should be equal.
WARNING
Y
Y
"Y" dimensions should be equal.
10 of 70
ISSUED: 10-30-09 SHEET #: 095-9299-11 03-22-12
X
X
Publicité
Table des Matières
