Introduction; Preconditions For Functioning Of The Remote Control - Waeco MagicTouch MT100 Manuel D'utilisation

RC-100.qxd 30/07/03
Depending on the vehicle's equipment, the following date may have to be
reprogrammed:
Radiocode · Clock · Timer · Board computer · Seat position
IInstructions on how to re-set these can be found in the relevant operatinginstructions.
Warning! The components of the RC-100 remote control which are inside the
vehicle must be securely fixed so that they cannot come loose and injure the
vehicle's occupants under any circumstances (emergency braking, traffic
accident).
Caution! To check the voltage in electric cables, use only a diode test lamp
(see A 1) or a voltmeter (see A 2). Test lamps (see A 3) which light up take too
much current and the vehicle electronics may be damaged.
Caution! To avoid damage, always ensure that there is enough clearance for
the drill bit to emerge (see A 4). Every drill hole must be deburred and treated
with a rust proofing agent.
Caution! Please make sure that the driver must not insert his hand through the
steering wheel to operate the control unit and that no components of the
"magic touch" are located within the radius of the vehicle airbags and the head
impact range.
WAECO International does not accept any liability for damages due to the following:
a) incorrect assembly
b) damage to the system by mechanical effects and over voltages
c) modifications to magic touch speed without the explicit approval of
WAECO International
d) use for any purposes other than those described in the assembly instructions.
The RC-100 remote control is a supplement to your vehicle's central locking system,
using a small transmitter which allows you to lock or unlock the doors of your vehicle.

Preconditions for functioning of the remote control

Your vehicle must have an operating voltage of 12 V.
Your vehicle must be equipped with central locking.
Some manufacturers equip their vehicles with an economy central locking system. In
these vehicles, there is no servo motor in the driver's door but only an electric switch. If
this is the case, a servo motor has to be retrofitted (e.g. WAECO Art. No. ML-11). To find
out whether a servo motor is already fitted, proceed as follows:
11:41 Page 35
Safety and installation instructions

Introduction

35