VINCENT PHO-8 Manuel D'utilisation page 20

4
5
7
8
4. AC/FUSE: power connector
and fuse holder
To establish the power supply, connect the
plugs of the power cable to the device and to
a wall power outlet. The small plastic housing
beneath the mains socket holds the fuse. Refer
to the Safety Guidelines.
5. POWER: mains switch
This is the main power switch for turning on
and off the PHO-8. Always switch on the
PHO-8 before you switch on the amplifier/pre-
amplifier!
6. DC OUT: Power supply output to PHO 8
Make a connection to the power supply input
(10) of the PHO-8 using the supplied 5pin DIN
cable.
7. MC/MM IN: signal input from
the record player
The audio output (or as well an attached audio
cable) of the record player must be connected
to these input sockets.
Vincent
20
REAR VIEW
8. GND: Ground clamp for the
record player
In addition to the stereo signal connection
cable most record players are equipped with
a grounding cable that can be recognized by
the cable lug at the end of the cable. This lug
has to be fitted to the clamp "GND".
9. OUT: signal output to the amplifier
A pair of RCA input sockets of your system's
audio amplifier must be connected with these
output sockets.
10. DC IN: power supply input of
the PHO-8
Make a connection to the power supply output
(6) of the PHO-8ps using the supplied 5pin
DIN cable.
6
9
10