Installation; I Mounting In The Rack - Panasonic WV-CU161C/B Mode D'emploi

Installation

CAUTION
• Installation should be performed by qualified service personnel or system installers according to the following instruc-
tions.
• Disconnect the power cord from the service outlet before installation.

I Mounting in the Rack

1. Remove the Connector Panel and Bottom Cover from
the controller by removing the four screws.
2. Mount the Connector Panel onto the bottom by using
the two screws that were removed above.
3. Mount the Bottom Cover onto the rear by using the two
screws that were removed above.
4. Remove the side panels by removing the four screws.
5. Remove the Palm Rest Panel by removing the two
screws.
6. Fix the Rack Mounting Angles onto both sides by using
the four screws.
7. Mount the controller in the EIA standard 19-inch rack.
Note: Always keep the temperature in the rack within 45 °C
{122 °F}.
Connector Panel
Bottom Cover
Bottom Cover
Connector Panel
4
Side Panel
(Left)
5
7
(Procured locally)
6
(Supplied:
WV-Q62)
Rack Mounting Angle
(Optional Accessory: WV-Q62)
1
3
2
Side Panel
(Right)
Palm Rest Panel
5
(Procured locally)
6
(Supplied:
WV-Q62)
4
9