I Rear View - Panasonic WV-CU161C/B Mode D'emploi

I Rear View

q Alarm Switch
This switch is used to specify the functions for the 5-pin
terminal adjacent to the switch. When the switch is set
to the upper position, the terminals supply and accept
the alarm related signals with a Time Lapse VTR. When
the switch is in the lower position, the terminals accept
alarm inputs 1, 2, 3 and 4.
w Alarm Terminals
Terminal functions are specified by the alarm switch
position as shown in the table. Refer to page 13 for con-
nection with a Time Lapse VTR.
Pin #
Up
Alarm Input
1
Alarm Output
2
Signal ground
G
Recover Input
3
Reset Output
4
e RS-485 Terminal
This terminal is used to exchange control data with the
camera site.
r Termination Switch (TERM ON/OFF)
This switch is used to terminate the RS-485 communi-
cation lines.
It should normally be kept in the ON position.
t Line Selection Switch (LINE 4/2)
This switch is used to select full-duplex (4-lines) or half-
duplex (2-lines) for the communication lines.
y Data Selection Switch (DATA COAX/RS485)
This switch selects the data communication route from
among the multiplexing data on a coaxial cable or when
using an RS-485 line.
8
ALARM
ALARM IN
ALARM OUT
T
RECOVER IN
RESET OUT
G B A
4 3 G 2 1
ALARM IN
q w e
Switch Position
Down
Alarm Input 1
Alarm Input 2
Signal ground
Alarm Input 3
Alarm Input 4
CAMERA
RS485 DATA VIDEO
OUT IN
R TERM LINE
B A
ON 4 COAX
OFF 2 RS485
rty u i
u Video Output Connector (VIDEO OUT)
This connector supplies composite video signals from
the camera.
i Camera Input Connector (CAMERA IN)
This connector accepts the multiplexed video and con-
trol data signals from the specified camera or a speci-
fied receiver.
o AC Cord
!0 Power Switch (POWER)
This switch is used to turn the System Controller power
on and off.
Caution: In the following cases, disconnect the AC
cord from the service outlet, or switch off an ALL-
POLE MAIN SWITCH with a contact separation of at
least 3 mm in each pole incorporated in the electri-
cal insulation of the building.
This is to be used when the controller needs to be
isolated from the AC mains, when the controller will
not be used for a long time, and when there is light-
ning.
!1 Signal Ground Terminal (SIGNAL GND)
POWER
ON OFF
SIGNAL GND
o !0 !1