Operating Procedures
CAMERA CONTROL FUNCTIONS
Camera control functions are operable.
It is necessary to set up the camera before using the cam-
era control functions. For further information, refer to the
Operating Instructions for the respective combination cam-
era (See page 33). You can also set it up from the Camera
Setup menu during operating the system.
I Pan/Tilt Control
A combination camera or an ordinary camera with pan/tilt
head can be controlled.
Move the pan/tilt head in the desired direction using the
joystick.
Joystick
To move the pan/tilt head slowly, move the joystick while
holding down the SLOW/CAMERA FUNCTION button.
Note: The SLOW/CAMERA FUNCTION button only works in
combination with cameras or pan/tilt heads that are pro-
vided with more than 8-step speeds.
I Lens Control
A motorized lens can be controlled.
1. Press the FOCUS NEAR or FOCUS FAR button to
adjust the lens focus while watching the monitor.
NEAR
FOCUS
AUTO FOCUS
If you are using a camera with an auto focus feature,
then the lens focus can be automatically adjusted by
simultaneously pressing the FOCUS NEAR and
FOCUS FAR buttons.
2. Press the ZOOM TELE button to zoom in on the object
or press the ZOOM WIDE button to zoom out from the
scene.
WIDE
ZOOM
CLOSE
IRIS RESET
The focal length differs depending on the lens installed
on the camera.
3. Press the SHIFT button.
SHIFT
4. Press the ZOOM/IRIS buttons to adjust the lens iris
while watching the monitor.
If the IRIS CLOSE and IRIS OPEN buttons are simulta-
neously pressed for approximately 1 second or more,
then the iris is reset to the default values.
WIDE
ZOOM
CLOSE
IRIS RESET
FAR
TELE
IRIS
OPEN
TELE
IRIS
OPEN
25