Panasonic WV-CU161C/B Mode D'emploi page 32

G Camera Patrol Learning
There are two ways of setting the camera patrol learning.
One is to use the setup menu and the other is to operate
the camera.
Follow the procedures described below to set the camera
patrol learning up while operating the combination camera.
1. Press the PATROL LEARN button while holding down
the PROGRAM button.
CAMERA
SETUP
SETUP
PROGRAM
[LEARNING] appears on the monitor.
Note: Pressing the PROGRAM button alone for 2 sec-
onds will change the screen to the WV-CU161C
SETUP MENU or camera SETUP MENU.
2. Operate the camera using the following controls so that
it traces the routine course that is the most frequently
patrolled. The learning is programmed for 30 seconds.
• Pan/Tilt (Joystick)
• Iris (Open/Close)
• Focus (Near/Far)
• Zoom (Tele/Wide)
• Preset position
Note: The memorized parameters may differ somewhat
depending on the camera type. Refer to the manual
included with the camera.
3. To stop the learning, press the PATROL STOP button
while holding down the PROGRAM button.
CAMERA
SETUP
SETUP
PROGRAM
[LEARNING] appears on the monitor.
32
PATROL
PLAY
PATROL LEARN
LEARNING
AUTO
B/W
PATROL STOP
G Camera Preset Position
There are two ways of presetting camera positions. One is
to use the setup menu of the combination camera and the
other is to operate the camera.
Follow the procedures described below to set up the cam-
era preset position while operating the combination cam-
era.
1. Move the camera to the position you wish to preset
using the joystick.
L
Adjust the picture using the following controls.
• Iris (Open/Close)
• Focus (Near/Far)
• Zoom (Tele/Wide)
Note: The memorized parameters may differ somewhat
depending on the camera type. Refer to the manual
included with the camera.
2. Type a number with the numeric buttons for the preset
position.
1
4
7
HOME
ESC
3. Press the PRESET/SET/PROGRAM PRESET button
while holding down the CAMERA SETUP/SETUP/PRO-
GRAM button.
The position and its number are memorized for future
recall.
CAMERA
SETUP
SETUP
PROGRAM
UP
R
DOWN
2 3
5 6
8 9
PRESET
0
SET
PROGRAM
PRESET
PRESET
SET
PROGRAM
PRESET