Walter LT63006S Notice D'utilisation page 51

Troubleshooting
Problem
The motor does not start.
The cut is not straight
The motor reaches full
speed with difficulty and
has no power.
The machine vibrates.
630355_Anleitung_D,GB,FR.indb 51
Problem Solution
Damaged cable.
Fuse tripped.
The fuse or the RCD
protection device can
trip if the motor is
overloaded.
Trigger defective
The saw blade is blunt.
The saw blade is fitted
the wrong was round.
The saw blade is
not suitable for the
workpiece.
An undersized extension
is being used.
The mains voltage is too
low.
The saw blade is
damaged.
51
Check whether the
machine is correctly
connected to the mains.
Have the battery charger
checked by customer
service
Check the household
fuse box
Check the household
fuse box
Have the trigger switch
checked by customer
service
Check that the saw
blade teeth are sharp.
Change the saw blade if
necessary.
The arrow printed on the
saw blade must point
in the same direction as
the arrow on the blade
guard.
Follow instructions
from the saw blade
manufacturer.
Ensure the extension
cable has a sufficient
conductor diameter of
2
1.5 mm .
Ensure local mains
voltage agrees with the
information on the rating
label.
Check the saw blade for
signs of damage.
11.12.15 11:07