Connecting to the mains
The machine is designed for use with single phase alternating current 230 - 240
V AC / 50 Hz and is double-insulated. Make certain that the rated voltage stated
on the device's rating plate matches the local mains voltage.
If the work area is not close to the mains outlet, use an extension cable with
sufficient conductor diameter (min. 1,5 mm)
The extension cable used should be as short as possible.
Working with the device
- Place the side of the workpiece that will be visible against the work bench
when cutting.
- Applying excess pressure reduces both the performance capabilities of
the saw and the life of the saw blade.
Switching on and off
To switch the machine ON:
Press the locking pin (3) and On/Off
switch simultaneously
To switch the machine OFF:
Release the On/Off switch.
For safety reasons the machine may not be 'locked-on'. The
trigger must be held at all times when operating the machine.
630355_Anleitung_D,GB,FR.indb 46
2
).
4
46
3
11.12.15 11:07