Adjusting The Cutting Depth; Setting The Mitre Angle - Walter LT63006S Notice D'utilisation

Adjusting the cutting depth:

Disconnect the machine from the mains before carrying out
any kind of maintenance or adjustments.
The cutting depth can be adjusted from 0 - 55 mm.
- Loosen the cutting depth adjustment
screw (6). Set the desired cutting
depth with the aid of the scale (7)
and tighten the screw.

Setting the mitre angle

Disconnect the machine from the mains before carrying out
any kind of maintenance or adjustments.
The mitre angle can be adjusted between 0° - 48°
- Loosen both mitre angle adjustment
screws (8). Set the desired angle on
the scale (9) and tighten the screws.
630355_Anleitung_D,GB,FR.indb 42
7
6
8
9
42
11.12.15 11:06