Access From The Internet; Setting The Admin Password Over A Secure Connection - Eneo IEP-63M2812M0A Guide D'installation Rapide

Access from the internet

Once connected, the network camera is accessible on your local network (LAN). To access
the network camera from the Internet you must configure your broadband router to
allow incoming data traffic to the network camera. To do this, enable the NAT traversal
feature, which will attempt to automatically configure the router to allow access to the
network camera. This is enabled from Setup > System > Network > NAT. For more infor-
mation, please see "System > Network > NAT" of User's Manual.

Setting the admin password over a secure connection

To gain access to the product, the password for the default administrator user must be
set. This is done in the Admin Password dialog, which is displayed when the network
camera is accessed for the setup at the first time. Enter your admin name and password,
set by the administrator.
i
Notice: The default administrator user name and password is admin. If the password
is lost, the network camera must be reset to the factory default settings. Please see "Re-
setting to the factory default settings".
To prevent network eavesdropping when setting the admin password, this can be done
via an encrypted HTTPS connection, which requires an HTTPS certificate (see Notice
below). To set the password via a standard HTTP connection, enter it directly in the first
dialog shown below. To set the password via an encrypted HTTPS connection, please see
System> Security > HTTPS of User's Manual.
i Notice: HTTPS (Hypertext Transfer Protocol over SSL) is a protocol used to encrypt
the traffic between web browsers and servers. The HTTPS certificate controls the encrypt-
ed exchange of information.
12