Sammic XM-12 Mode D'emploi page 10

EN
as explained in the section dealing with rinsing.
To disinfect the stirrers, first remove the beater arm reducer unit from
the rest of the beater. Remove the stirrers by pulling the beater arm
outwards. Using a soft cloth moistened with the disinfectant solution,
clean any food residues that may remain on the stirrers. Let the stirrers
soak in the disinfectant solution (5 liters, depending on the recipient
used) for at least 30 minutes totally covered. Rinse the soap residues
from the stirrers with hot water (35- 45ºC) as explained in the section
dealing with rinsing.
RINSING PROCEDURE
Rinse the element with clean running water (at least 5 litres), removing
any disinfectant and soap residue. Finally, allow to dry at room
temperature. The motor block should only be cleaned with a damp cloth.
Under no circumstances should water enter into the motor block. If water
accidentally penetrates inside the motor block, dry it completely before
reconnecting the appliance. After cleaning, return the appliance to its
wall bracket.
MAINTENANCE.
Contact an authorised technical service if:
• When you check the power cable you see that it's damaged.
• When you check the status of the lower seal (9) you see that it's
damaged.
• When you check the status of the blade (8) you see that it's jagged.
• If the upper pilot light (3) doesn't turn on when you plug the appliance
in.
• If, when you turn the motor on, the speed doesn't change when you
move the adjustment control (4).
• If you can see that the outer casing is damaged or has cracks.
• If, with the red pilot light (3) turned on, the motor doesn't start when
you press the "On" button (5), the motor's thermal protector may have
been triggered. In this case, you will notice that the outside of the
case is hot. Wait until the machine cools down and try again. If the
appliance doesn't start, contact the authorised technical service.
OTHER IMPORTANT REMARKS
The airborne noise emitted by the machine, measured on a specimen
machine, is lower than 80dB(A), distance 1 m.
10
- 10 -