Maintenance And Care - Flex PE 150 18.0-EC Notice D'utilisation

Instruction manual
4. Remove the battery from the charger.
5. Pull out the mains plug.
NOTE
If the display flashes after the battery is
inserted in the charger, there is a fault in the
battery or in the charger.
Display flashes slowly.
Backlighting orange.
The battery is too hot or too cold.
The charging process starts when the
battery reaches the charging temperature
(0°C...55°C).
Display flashes rapidly.
Backlighting red.
Remove the battery from the
charger and insert again. If the same display
persists, the battery is faulty. Replace the
battery or have it checked at an authorised
repair shop.
If this error message is displayed again with
a different battery, this indicates that there
is a fault in the charger. Have the charger
checked at an authorised repair shop.

Maintenance and care

WARNING
Risk of electric shock! Before carrying out
any work on the power tool, always remove
the battery.
14
Cleaning
Regularly clean the power tool and venti-
lation slots. Frequency of cleaning is depen-
dent on the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
CAUTION
Risk of injury! Wear safety glases while
using compressed air.
All plastic parts should be cleaned with soft
damp cloth. NEVER use solvents to clean
plastic parts. They could possibly dissolve
or otherwise damage the material.
1. Clean the power tool and grille in front of
the vent slots regularly. Frequency of
cleaning is dependent on the material
and duration of use.
2. Regularly blow out the housing interior
and motor with dry compressed air.
3. Regularly clean the filter cover.
4. Remove filter cover and blow it out with
dry compressed air.
Storage
Keep polisher, tools, accessories and
charger on a dry, clean and cool place
PE 150 18.0-EC