Operating Instructions; Attaching The Auxiliary Handle; Inserting/Replacing The Battery; Battery State Of Charge - Flex PE 150 18.0-EC Notice D'utilisation

Instruction manual

Operating instructions

WARNING
Risk of electric shock! Before carrying out
any work on the power tool, always remove
the battery.
Before switching on the power
tool
Unpack the polisher and check that there
are no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.

Attaching the auxiliary handle

The auxiliary handle can be attached
to improve handling of the polisher.
To do this, remove the handle cover
fastening screw from the side on which the
handle is to be attached.
When removing the handle, put back
the screw which was removed beforehand.
10

Inserting/replacing the battery

1. Press the charged battery into the
power tool until it clicks into place.
2. To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!

Battery state of charge

1. Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
PE 150 18.0-EC