Evolution EvoMAG42 Traduction De La Notice Originale page 16

(>9.12)
SETTING UP
WARNING: Before using the machine ensure that you have
read the sections on the intended and prohibited of use of
this machine.
This machine should only be used for hole boring/drilling
whilst attached to the work piece by the electromagnetic base.
WARNING: This machine is intended for use at any position,
but only if the electromagnet is in full working order and has
sufficient hold on the work piece material.
The safety strap or chain should be attached in case of power
failure or machine malfunction.
The safety strap or chain should NOT be used as an alternative
to the magnet for clamping purposes.
Always ensure the strap or chain is correctly fitted and the
machine is secure BEFORE starting the machine. (9.12<)
(9.20)
COOLANT / LUBRICANT FLOW.
Note: It is recommended that a Soluble Oil is used as other
coolants/lubricants may have a high viscosity and may not
flow easily to the cutter.
Ensure that the Coolant/Lubrication bottle is filled with
suitable Coolant/Lubrication liquid and that the ON/OFF tap is
in the ON position.
• Ensure that the work piece is flat, clean and free from any
rust, coatings or other contamination.
• Position the machine onto the work piece.
• Connect the plug into a mains supply socket and switch on
at the socket. (UK only)
• Energise the magnetic base by operating the Magnet
'ON/OFF' switch.
The machine should now be firmly attached to the mild steel
plate.
Before commencing the cutting operation check that there is
sufficient Coolant/Lubrication flow at the cutter.
16
www.evolutionpowertools.com