Evolution EvoMAG42 Traduction De La Notice Originale page 11

www.evolutionpowertools.com
• If necessary repeat the above procedure
several times to ensure that all free
movement has been eliminated and that
the machine head moves up and down
freely without any binding and without any
side to side movement.
• Re-tighten the 3 cap screws when
adjustment is complete.
(9.6)
4) COOLANTS and LUBRICANTS.
The use of coolants or lubricants will ease the
cutting operation and prolong the life of the
cutter and the machine.
• When using coolants or lubricants, ensure
that they do not run down the mains cord
to the mains plug and supply outlet. Do not
allow coolants or lubricants to enter the
machine's ventilation openings.
• When using the machine in an inverted
position or on vertical surfaces use cutting
paste instead of a liquid cutting fluid.
• If the machine is to be used to cut materials
that create dust, such as cast iron, dust
extraction equipment (not supplied) should
be used and/or the operator should wear a
suitable respiratory protection mask.
(9.8)
5) PREPARATION and SETTING UP.
The electromagnet on this machine is
designed to adhere to ferrous metallic
surfaces only.
WARNING: The electro magnet fitted to
this machine is a two stage magnet. With
the machine positioned, and the magnet
switched 'ON' but the motor switched 'OFF' the
magnet is at 50% strength. The magnet only
reaches full strength when both the Magnet
and Motor switches are in the 'ON' position.
WARNING: The use on any material whose
thickness is less than that specified in
this Instruction Manual will progressively
reduce the magnetic performance, and
could result in a potentially dangerous
condition arising.
(9.9)
• Always prepare the material surface before
attaching the machine.
The material surface must be clean, flat and
free from rust, protective coatings, grease
or other debris such as chips or swarf from
previously drilled holes.
• Always check the surface of the magnetic
base ensuring that it is not damaged and
is clear of debris such as chippings or swarf
from previously drilled holes.
• Never use this machine on a structure
where arc welding is taking place. Damage
to the machine will result as the welder will
ground through the power tools ground or
earth cable.
(9.10)
6) DURING CUTTING OPERATIONS.
WARNING: The swarf and the slug
produced will be hot and sharp.
• When using annular cutters ensure that the
slug ejected at the end of the cut will not
endanger anyone in the vicinity.
• If working at height some form of collection
device for the ejected slug may be necessary.
• Care should be taken with the ejected
slug, this will be both hot and sharp, gloves
should be worn when handling the slug.
• This power tool can be used on a vertical
surface or upside down provided there is
sufficient magnetic adhesion, extra care
should be taken when drilling vertically or
inverted . When using the machine vertically
or inverted it is possible hot and sharp swarf
or chips may fall. Always wear appropriate
personal protective equipment.
(9.11)
7) SAFETY STRAP OR SAFETY CHAIN.
WARNING: The electromagnet base on this
power tool can deactivate if the power supply is
interrupted or suffers an electrical malfunction.
• To prevent possible operator injury, the safety
strap or chain supplied should be used at all
times to provide extra security in the event of
supply failure or electrical malfunction.
11
EN
ES
FR
TR