solamagic DS 02007 Instructions De Montage page 34

Wireless remote control (continued)
Complete deletion:
Changing the battery of the hand-held transmitter
Warning: Do not touch the battery directly with the skin.
Open the housing cover. Push the battery out
sideways from the clamped position and remove.
Insert the new battery (plus to the top) and
reassemble the unit in reverse order.
Note: This action deletes all receivers that are
within range of the hand-held transmitter.
Programmed infrared heaters can also be deleted
(reset) upon loss of a hand-held transmitter or if it
becomes defective. The deletion process is only
possible within 180 seconds of connection to the
mains of the infrared heater in question. (If
necessary, disconnect the infrared heater from the
mains and then reconnect.)
To delete, simultaneously hold down buttons 1 and
2 of the hand-held transmitter for longer than 3
seconds. When doing so, the red control lamp of
the hand-held transmitter only illuminates once
deletion is enabled. Now release the buttons and
directly thereafter briefly press both buttons
simultaneously. The control lamp on the hand-held
transmitter illuminates briefly when the deletion
signal is sent. LED 1 flashes on the infrared heater
(10 Hz).
These receivers can again now be reprogrammed
as described under "Programming" above.
02/2015