solamagic DS 02007 Instructions De Montage page 33

Wireless remote control (continued)
Multiple
programming:
Safety switch-
off:
Reprogramming of the remote control
Selective deletion:
02/2015
It is possible to program infrared heaters on up to
eight keys on one or more hand-held transmitters
(multi-control).
The corresponding infrared heaters are connected
to the mains (normal flashing of LED 1 at 10 Hz).
As described under "Initial programming", the key
to be programmed is briefly pressed (LED 3
illuminates) and
pressing (normal flashing of LED 1 at 10 Hz). Then
the next key is programmed by pressing (LED 3
illuminates) and then confirming (normal flashing of
LED 1 at 10 Hz). This process is repeated until all
the desired buttons on all the desired hand-held
transmitters are programmed.
The multiple programming is ended by long
pressing of a key on one hand-held transmitter
(LEDs 1+2+3 for two seconds).
The infrared radiator always remains switched off
after a power outage.
Already programmed infrared heaters can be
deleted and
corresponding hand-held transmitter.
To do this press and hold buttons 1 and 2 of the
hand-held transmitter simultaneously until the
control lamp on
illuminates. Deletion is now enabled.
Now release the buttons and directly thereafter
briefly press that key with which the radio receiver
was operated up until now.
The control lamp on the hand-held transmitter
illuminates briefly when the deletion signal is sent.
LED 1 flashes on the infrared heater (10 Hz).
These receivers can again now be reprogrammed
as described under "Programming" above.
confirmed through
reprogrammed
the hand-held
repeated
using the
transmitter