solamagic DS 02007 Instructions De Montage page 32

Wireless remote control (continued)
Programming of the wireless remote control
Important:
Initial programming:
 Only those infrared heaters should be connected
to the mains that are to undergo programming to
a hand-held transmitter key. In this way several
receivers can be programmed (multipower).
Already programmed infrared heaters can remain
connected to the mains.
 Use of other components with a radio-signal
interface (e.g. wireless PC mouse and keyboard)
can result in faulty operation of the radio receiver.
Switch off all
particularly when programming.
 The radio receiver is briefly disabled after
command entry using the hand-held transmitter.
This is signalled by flashing (10 Hz) of LED 3.
The infrared heaters to be programmed are
connected to the mains. Enabling for automatic
programming is signalled by flashing (10 Hz) of
LED 1.
Now brief pressing of the desired KEY on the
hand-held transmitter
programming (LED 3 flashes). Repeated pressing
of the same key confirms the programming (LED 3
flashes again).
If desired, time-out switching can be programmed
by double-clicking: If the programmed key is
pressed briefly twice in succession, the heater will
switch off in 30 minutes. LED 2 flashes in a quick
rhythm (30 Hz). Double-clicking again increases
the heating duration to 60 minutes (normal flashing
at 10 Hz). Double-clicking again increases the time
before switching off to 90 minutes (slow flashing at
3 Hz). Double-clicking once more switches the time
control off. The programming cycle for time-out
switching begins again from the beginning.
Programming is ended by long pressing of the
programmed key of the hand-held transmitter. At
this point LEDs 1+2+3 signals the completion of
programming for two seconds.
other wireless components,
triggers radio receiver
02/2015