Electric Connection - Bartscher IKTS 35 Mode D'emploi

5.3 Electric connection

WARNING!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared
with that of the device (see type label). Connect the device only in case of
compliance!
The device must only be connected to a properly installed single socket
with protective contact.
Never remove the power cable by pulling the cable itself; always grab
the plug housing.
•
Never allow the power cable to come into contact with heat sources or sharp edges.
The power cable should not hang over the side of the working surface. Ensure that no
one can step on or trip over the cable.
•
The power cable must not be folded, bent or tangled, and must always remain fully
unrolled.
•
Never place the device or other objects on the power cable.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
- 36 -
Electric shock hazard!